Excalibur 366 Dokumentacja Pobierz pdf (Strona 98)

Excalibur Multirate DAP Installation and Operation

5-10

Table 5-2. DAP Parameters (Continued)

Parameter Possible Settings

Latching Loopback

(Latch) Enabled, Disabled

Transmit Calibrate

(TxCal) Accept

Pattern (Pttrn) 2047, 511

Secondary Channel

(SecCh) Clear Secondary Channel, Remote

Control Panel

Network Delay

(NetDl) Short, Medium, Long, Extra Long

Automatic Poll

(APoll) Enabled, Disabled

Modify Drop Table

(ModDT) Add, Delete

One's Density

(1Dens) Enabled, Disabled

1. This parameter appears on the screen when the service is set for DDS, DDS-SC,

or DDSNI. This parameter does not appear on the screen when the service is set

for LADC, LDM, CC64, or C64NI. For these services, the unit defaults to point-

to-point.

2. This parameter appears on the screen only when the RTS Simulation parameter is

disabled.

3. This selection appears on the screen only when the service is set for LADC or

LDM.

4. This parameter does not appear on the screen when the interface is V.35 or when

the service is set for DDS or CC64. (The unit defaults to Signal Quality.)

5. This parameter does not appear on the screen when the interface is V.35.

6. This parameter appears on the screen only when the service is set for DDSNI,

CC64, or C64NI.

7. For units equipped with the 15P09AA or Model D Aggregate card, extended

range operation is automatic and this parameter does not appear on the screen.

For units equipped with older Aggregate cards (Model A or C), the following

conditions apply: (1) When the service is set for LADC or LDM, this parameter

appears for all DTE rates. (2) When the service is set for DDS, DDSNI or DDS-

SC, this parameter appears on the screen only when the DTE rate is 19.2 Kbps or

greater. (3) This parameter does not appear on the screen when the service is set

for CC64 or C64NI.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 253 254

Brak uwag

Excalibur 366 Dokumentacja Strona 98